The DM1100 C and DM1600 C are edge rounding machines designed with ease of use and simplicity in mind. The process is straightforward – simply feed the part into the machine, where it passes through two sets of abrasive blocks, working in opposite directions. Upon exiting the machine, the part will have perfectly rounded edges with no rough edges or burrs on both its inner and outer contours, providing a sleek, professional finish.

1. LESS SET-UP TIME

It is a myth that programmable controllers always make deburring machines easier and faster to set up. The Input through directly coupled hand wheels and simple on/off buttons is the fastest and most intuitive, safe way to change the setup. You can change over from one job to the next in single-digit seconds including changing material thickness, feed rate, and grinding pressure.  And all that on the fly without stopping the machine.

2. FASTER OPERATOR TRAINING

A skilled worker is oftentimes defined as someone experienced in running a specific type of equipment. Training an operator for these machines is simple thanks to minimal programming requirements.

“Anybody can run it.
You just set the height and let it do its work.”

Steve Anderson, president, G.A. Systems Inc.

3. LESS COMPONENT FAILURE

Complexity translates into downtime.  And simple and good is difficult.  So, we put effort behind simplicity.  And that leads to superior uptime of our C Equipment with a lower cost of ownership.

4. FEWER OPERATOR MISTAKES

Easy-to-operate machines cause less operator error.  As the operator can visually see and sense his inputs costly mistakes are avoided and your parts keep flowing through the machine. This increases both operator confidence and productivity. A win/win!